GE Voluson E Series User Manual

3.13.2.6 Removing a WLAN Profile
1.
Press the Utilities key on the control console.
2. On the right side of the screen select Connectivity and then click the Device Setup tab.
3. Click the WLAN Configuration button; see Figure 3-44 on page 3-58 .
4. The Wireless Network Configuration tool with available Wireless Networks appear.
5. Select the Security tab and then click Remove .
3.13.2.7 Customizing an existing WLAN Profile
1. Press the Utilities key on the control console.
2. On the right side of the screen select Connectivity and then click the Device Setup tab.
3. Click the WLAN Configuration button; see Figure 3-44 on page 3-58 .
4. The Wireless Network Configuration tool with available Wireless Networks appear.
5. Select the Security tab and then click Customize .
Figure 3-48 Security - Customize
6. Customize the following information:
-
Network Name (SSID)
-
Check box "Connect even if Network is not Broadcasting its Name (SSID)"
-
Network Authentication (Open, Shared Key, WPA PSK
6
or WPA2 PSK)
-
Data Encryption
-
Network Key
-
Key Index
7.
After you have filled in all the required information, click
OK .
6 WPA(2) PSK = WiFi Protected Access using one Pre-Shared Key Note: PSK is also referred to as "Personal" encryption standard.
Setup Instructions
Voluson E-Series Service Manual
5539550APB Revision 6
3-61

GE Voluson E Series Specifications

General

Brand	GE
Model	Voluson E Series
Category	Medical Equipment
Language	English