21. If the Touch panel is not working after first boot up, please shutdown the system; then boot up again.
Note
After turning off a system, wait at least 10 seconds before turning it on again. The system may not be able to
boot if power is recycled too quickly.
22. Reconnect the external devices, install all the printers and adjust the printer settings as described in
Section 3.6 "Printer Installation" on page 3-36
.
23. Check and match Printer Remote Control selection in the
Setup - Connectivity - Button Configuration
page.
24. Confirm date and time setting in the
Setup - General Settings - General
page.
25. Perform Software and Functional checks as described in
Section 8.3 on page 8-14
.
Replacement Procedures
Voluson E-Series Service Manual
5539550APB Revision 6
8-9