Finally the 2D screen with the "New Software Verification" report is displayed on the monitor.
Figure 8-18 New Software Verification
16. Reconnect the external devices, install all the printers and adjust the printer settings as described in
Section 3.6 "Printer Installation" on page 3-36
.
17. Check and match Printer Remote Control selection in the
Setup - Connectivity - Button Configuration
page.
18. Confirm date and time setting in the
Setup - General Settings - General
page.
19. Perform a check of all modes and features listed. (Move the cursor over the feature name to get
information how to check.)
20. When all features are
OK
enter your signature and then click
Send
; see:
Figure 8-18 above
.
Note
If one feature gets "Failed", rollback the installation (restore the previously used system configuration). For
more detailed information, see Section 5.15.3 on page 5-53 .
Replacement Procedures
Voluson E-Series Service Manual
5539550APB Revision 6
8-13
To Next Page
Loading...
