8.8.3.4 Mounting/Replacing the Printer Box
Manpower
One person, 3 minutes
Tools
Phillips screwdriver PH1 and PH2
Preparations
1.
Power Off/Shutdown the system as described in
Section 4.2.2 on page 4-4
.
2. Remove the Printer Flap as described in
Section 8.8.3.3.1 on page 8-20
.
3. Remove the Voluson covering and rectangular covering strip (Front Frame) as described in
Section
8.8.2.1 on page 8-18
.
8.8.3.4.1 Printer Box - Installation Procedure
1. Place the (new) Printer Box on its original position.
Note
Make sure to hear the hinges snap.
Figure 8-25 mount Printer Box
Replacement Procedures
Voluson E-Series Service Manual
5539550APB Revision 6
8-21
To Next Page
Loading...
