Maintenance and tests
User Manual corpuls
3
216 ENG - Version 2.1 – P/N 04130.2
9.4.2 Metrological Check
Pursuant to § 11 MPBetreibV (Medical Device Operators’ Ordinance, applicable
to the Federal Republic of Germany), it is mandatory to perform metrological
checks every 2 years on the non-invasive blood pressure (NIBP) and
temperature measurement functions.
For all further measurement functions included in the corpuls
3
(ECG,
Oximetry, CO
2
, IBP), regular metrological checks are recommended.
If a malfunction is suspected, it is mandatory to perform metrological checks.
In states outside Germany, the national regulations or those based on EC
directives concerning the scope and timely performance of metrological checks.
Caution
Metrological checks may only be performed by authorised personnel with
calibrated measuring devices, measurement standards and simulators.
9.4.3 Repair and Service
Any inspection, maintenance and cleaning tasks other than those listed in
chapter 9.2 Function Checks, p. 207 may only be performed by authorised
technicians.
Warning
The defibrillator must not be opened. Inside components may carry high
voltages. Failure to observe this may result in severe injuries or death.
Have the corpuls
3
tested and repaired if necessary by an authorised sales
and service partner if a defect is suspected.
Repair and service may only be performed by authorised sales and service
partners. If technical repairs are not performed by trained technicians instructed
by the manufacturer, this many result in damage to the corpuls
3
and loss of
any claim under the warranty of GS Elektromedizinische Geräte G. Stemple
GmbH.
To avoid transport damage when dispatching devices, care should be taken to
ensure they are suitably packed. Ideally, the original packaging should be used.
Packaging instructions and guidelines are available on request from GS
Elektromedizinische Geräte G. Stemple GmbH.
To Next Page
Loading...
