Appendix
User Manual corpuls
3
278 ENG - Version 2.1 – P/N 04130.2
C Factory Settings
The corpuls
3
is delivered with a factory configuration to which the device can
be reset at any time by the person responsible for the device.
The factory configuration settings concern general system settings, on the one
hand, and, on the other hand, configurations of views and alarm limits are also
pre-set here.
The System – Master data entries are not reset during resetting to factory
settings.
Field Value/Setting
System
Language
Selection English
Display
Brightness 7
Dim mode 3
AutoDim after 5min
Colours Default
Manual event
Audio recording Disabled
Volume 10
Screenshot Disabled
Mains filter
Frequency 50 Hz
Printer - Curves
Settings
Speed 25mm/s
AutoOff OFF
Same as screen Activated
Printer - Trend
Protocol
Trends Activated
Trends
Same as screen Activated
Interval 5min
Average 60 Sek.
To Next Page
Loading...
