1-5
GE2/0/3 UP 1G F A 3
GE2/0/4 UP 100M(a) F(a) A 1
# Display the brief information about all but Ethernet interfaces.
<Sysname> display interface brief | exclude GE
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
NULL0 UP UP(s) --
Vlan1 UP UP 192.168.0.102
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Speed or Duplex: (a)/A - auto; H - half; F - full
Type: A - access; T - trunk; H - hybrid
Interface Link Speed Duplex Type PVID Description
BAGG1 DOWN auto A A 1
# Display information about interfaces in DOWN state and the relevant causes.
<Sysname> display interface brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
GE2/0/8 DOWN Not connected
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
BAGG1 DOWN Not connected
GE2/0/1 DOWN Not connected
GE2/0/2 DOWN Not connected
GE2/0/4 DOWN Not connected
GE2/0/5 DOWN Not connected
Table 1-1 display interface brief command output description
Field Description
The brief information of
interface(s) under route
mode:
The command displays brief information about Layer 3 interfaces
Link: ADM -
administratively down;
Stby - standby
AMD
indicates that the interface has been shut down by the network
administrator. To recover its physical layer state, perform the
undo shutdown
command.
Stby
indicates that the current interface is a standby interface.
Protocol: (s) - spoofing
If the network layer protocol state of an interface is shown as UP, but its link is an
on-demand link or not present at all, its protocol attribute includes the spoofing
flag (an
s
in parentheses). This attribute is typical of interface Null 0 and the
loopback interfaces.
Interface Interface name