H3C S7500E Series

20-7
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256
characters.
Description
Use the display lldp neighbor-information command to display the LLDP information carried in
LLDP TLVs sent from the neighboring devices.
Examples
# Display the LLDP information sent from the neighboring devices received through all the ports.
<Sysname> display lldp neighbor-information
LLDP neighbor-information of port 1[GigabitEthernet2/0/1]:
Neighbor index : 1
Update time : 0 days,0 hours,1 minutes,1 seconds
Chassis type : MAC address
Chassis ID : 000f-0055-0002
Port ID type : Interface name
Port ID : GigabitEthernet2/0/1
Port description : GigabitEthernet2/0/1 Interface
System name : Sysname
System description : System
System capabilities supported : Bridge,Router
System capabilities enabled : Bridge,Router
Management address type : ipv4
Management address : 192.168.1.55
Management address interface type : IfIndex
Management address interface ID : Unknown
Management address OID : 0
Port VLAN ID(PVID): 1
Port and protocol VLAN ID(PPVID) : 1
Port and protocol VLAN supported : Yes
Port and protocol VLAN enabled : No
VLAN name of VLAN 1: VLAN 0001
Auto-negotiation supported : Yes
Auto-negotiation enabled : Yes
OperMau : speed(1000)/duplex(Full)
Power port class : PD
PSE power supported : No
PSE power enabled : No
PSE pairs control ability : No
Power pairs : Signal
Port power classification : Class 0
Link aggregation supported : Yes
Link aggregation enabled : No