Harris IconMaster - Page 33

IconMaster Installation and Configuration Manual 17
Chapter 2: Installation
14. Initialize IconMaster
page 126
15. Configure IconMaster control panel
page 147
16. Customize push buttons on control panel
page 63
Scenario 11: Audio Control Panel Ordered Separately, Fader Bar
Ordered Separately, Optional Modules Ordered Separately; Internal
(NSM) Routers Preinstalled
Step Explained
1. Install fader bar
page 64
2. Connect main control panel to audio control panel
page 21
3. Mount the control panel(s) into a desktop or a rack
page 23
4. Connect the control panel to another device
page 28
5. Install NEO options into NEO frame
page 35
6. Install NEO frame into a rack
page 37
7. Configure NSM modules
page 77
8. Attach breakout modules
page 43
9. Connect the NEO modules to another device
page 38
10. Check card-edge parameters are set to your preferences
page 69
11. Initialize IconMaster
page 126
12. Configure IconMaster control panel
page 147
13. Customize push buttons on control panel
page 63
Scenario 12: Audio Control Panel Ordered Separately, Fader Bar
Ordered Separately, Optional Modules Ordered Separately; External
Router
Step Explained
1. Install fader bar
page 64
2. Connect main control panel to audio control panel
page 21
3. Mount the control panel(s) into a desktop or a rack
page 23
4. Connect the control panel to another device
page 28
5. Install NEO options into NEO frame
page 35
6. Install NEO frame into a rack
page 37
7. Mount external router into a rack (see specific router manual)
Scenario 10: Audio Control Panel Ordered Separately, Optional Modules
Ordered Separately; Platinum Router, CENTRIO, eBox (Continued)
Step Explained