38
Initial Measurement Preparations
Installing the battery pack
Be sure to read “Using Battery Pack” (p. 9).
The battery pack is subject to self-discharge. Be sure to charge the battery pack before initial use
(See Step 7).
If the battery can only be used for a considerably short time even after correct charging, replace it
with a new battery pack.
Required items
Phillips screwdriver (No. 2)
Model Z1003 battery pack
1
Turn off the instrument. (p. 44)
2
Remove all cords.
3
Turn the instrument over, remove
the screws on the primary battery
compartment and remove the cover.
4
Connect the plug of the Model Z1003
battery pack to the connector of the
instrument. (Turn the 2 projection
surfaces of the plug to the left and
connect.)
Projection
5
Insert the battery pack in the direction
that is indicated by the labeling on the
battery pack.
Be careful not to pinch the wires of the battery
pack.
6
Put the cover and tighten the screws.
7
Connect the AC adapter (p. 43) to the
instrument and charge the battery pack.
The battery pack will be charged regardless of
whether the power is ON or OFF.
CHARGE LED
Solid red During charging
Off Fully charged or when the
battery is not attached
(Left side surface of the instrument)
• The battery pack is used as a backup power supply for the instrument during interruption. When fully
charged, it can provide backup power for approximately 8 hours in the event of an interruption.
• Note that if an interruption occurs while the battery pack is not being used, the displayed time series data will
be erased. (Data that has been recorded on the SD memory card and instrument’s internal memory will be
retained.)
• For more information about the operating temperature and humidity and the storage temperature and
humidity, see “14.1 General Specications” (p. 153).
To Next Page
Loading...
Need help?
General
