9
Precautions for Use
Precautions for Use
Be sure to follow the precautions listed below in order to use the instrument safely and in a manner
that allows it to function eectively.
Use of the instrument should conform not only to its specications, but also to the specications of
all accessories, options, and other equipment in use.
Installing the instrument
WARNING
Do not install the instrument in locations such as the following:
• In locations where it would be subject to direct sunlight or high temperatures
• In locations where it would be exposed to corrosive or explosive gases
• In locations where it would be exposed to powerful electromagnetic radiation or close
to objects carrying an electric charge
• In locations close to inductive heating devices (high-frequency inductive heating
devices, IH cooktops, etc.)
• In locations characterized by a large amount of mechanical vibration
• In locations where it would be exposed to water, oil, chemicals, or solvents
• In locations where it would be exposed to high humidity or condensation
• In locations with an excessive amount of dust
Doing so could damage the instrument or cause it to malfunction, resulting in bodily
injury.
CAUTION
Do not place the instrument on an unstable stand or angled surface.
Doing so could cause the instrument to fall or overturn, resulting in bodily injury or
damage to the instrument.
• Leave at least 30 mm of space on every surface other than the underside to keep the instrument’s
temperature from rising.
• Leave at least 15 mm of space underneath the installation surface (the height of its feet).
• Place with its bottom side facing downward.
• Do not block vent openings.
30 mm or longer30 mm or longer
To Next Page
Loading...
Need help?
General
