247
Disposal of the Instrument (How to Remove the Lithium Battery)
11.10 Disposal of the Instrument
(How to Remove the Lithium Battery)
When disposing of the instrument, remove the lithium battery and dispose of the battery in
accordance with local regulations. Dispose of all optional accessories in accordance with applicable
instructions.
WARNING
Before removing the lithium battery, turn o the instrument and remove
the power cord and the measurement cables from the object under
measurement.
Do not short-circuit the battery.
Do not charge the battery.
Do not disassemble the battery.
Do not throw the battery in the re or heat the battery.
Doing so can cause the battery to explode, resulting in bodily injury.
Keep the removed battery out of reach of children.
CALIFORNIA, USA ONLY
Perchlorate Material - special handling may apply.
Visit www.dtsc.ca.gov/hazardouswaste/perchlorate.
Tools to be prepared
Phillips screwdriver (No. 2), hexagon wrench (width across ats: 2.5 mm), at-head screwdriver (long shaft)
1
Turn o the instrument.
2
Unplug current sensors, voltage cords, the
power cord, and any other cords or cables.
3
Remove the 16 screws for the handles using
the hexagon wrench.
4
Remove the four handles.
5
Remove the 10 screws securing the top
cover using the Phillips screwdriver.
6
Lift up on the back securing the top cover to
remove it.
7
Remove the USB cable from the printed
circuit board.
8
Insert the tip of the at-head screwdriver
between the battery holder on the internal
printed circuit board and the battery and lift
up on the battery to remove it.
Maintenance and Service
To Next Page
Loading...
Need help?
General
