HP 262SA - Page 52

Configuring the Terminal
Table 3-4. Datacomm Configuration
Menu Fields
BaudRate
This field specifies at what speedyou want the data transmis-
sion to take place (in bits per second).
Values:
110
150
300
600
1200
2400
4800
1
9600
19.2K
Parity/DataBits
(Point-to-point
only)
Parity
(Multipoint
only)
3-16
These fields specify the type of parity generation and number
of data bits to be used for each character.
NONE 18: (no parity bit)
o' 5 17: (parity bit always zero) (default)
ODD/7: (odd parity)
1'5/7: (parity bit always one)
EVEN/7: (even parity)
Default = 0' 5 I 7 (Full duplex hardwired)
ODD 17 (Full duplex modem)
This field specifies what type of parity generation and check-
ing you wish used with each data character. Pa,.rity is referred
to as a Vertical Redundancy Check (or VRC, for short).
Parity is only used with 7-bit data codes. If the terminal is
configured for 8-bit code (Code=ASCI 18), this field should be
set to None.
Values:
l' 5 (parity bit always one)
0' 5 (parity bit always zero)
ODD (odd parity)
EVEN (even parity)
None
Default= Odd