HP 262SA - Page 58

Configuring the Terminal
Table
3-4. Datacomm Configuration Menu Fields (Continued)
For compatibility with the HP 1000 and 3000 computers the
group ID for polling should be limited to the following:
A through Z
SPACE
@
Default=A
~
".,
"';.1
'.'.'
DeviceID
(Multipoint
only)
SRRXmit
(Full Duplex
Hardwired
only)
3-22
This field specifies the device identification code for the termi-
nal. The specified device ID is used by the host computer (in
conjunction
with a groupID) in both poll and selectsequences.
The device ID may be any of the following listed ASCII charac-
ters.
NOTE: The quotation mark(II) is used for group polling, and
should never be used as
the device ID.
SPACE ~ # $ % & I
() *+, -. /
o through 9
: ; < = ) ? @
A through Z [ / ] "
a through z '
{ I
Default= A
This field specifies whether or not a true (most positive volt-
age)
state on the Secondary Receiver Ready(SRR) (Secondary
Carrier Detect (SCF» control line is a required condition for
transmitting data. This mechanism is primarily used in con-
junction with printers which must be able to control the trans-
mission of data from other devices. The control line is
connected to RS-232-C, pin 12.
For menus in which this field is not present, SRRJSCF is not
required to transmit.
Values: Yes
No
Default =No