224
Use undo private-vlan isolated to restore the default.
Syntax
private-vlan isolated
undo private-vlan isolated
Default
Ports in the same secondary VLAN can communicate with each other at Layer 2.
Views
VLAN view
Predefined user roles
network-admin
Usage guidelines
This command takes effect when the following conditions exist:
• The secondary VLAN is associated with a primary VLAN.
• The ports are configured as host ports or trunk secondary ports of the secondary VLAN.
This command is mutually exclusive with the primary VLAN, super VLAN, and sub-VLAN
configuration commands.
Examples
This example shows how to meet the following requirements:
• VLAN 4 is a secondary VLAN, and it is associated with primary VLAN 2.
• GigabitEthernet 1/0/1 is a promiscuous port of VLAN 2.
• GigabitEthernet 1/0/2 and GigabitEthernet 1/0/3 are host ports.
• GigabitEthernet 1/0/2 and GigabitEthernet 1/0/3 are isolated at Layer 2 in secondary VLAN 4.
# Configure VLAN 2 as a primary VLAN and associate it with secondary VLAN 4.
<Sysname> system-view
[Sysname] vlan 4
[Sysname-vlan4] quit
[Sysname] vlan 2
[Sysname-vlan2] private-vlan primary
[Sysname-vlan2] private-vlan secondary 4
[Sysname-vlan2] quit
# Configure GigabitEthernet 1/0/1 as a promiscuous port of VLAN 2.
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port private-vlan 2 promiscuous
[Sysname-GigabitEthernet1/0/1] quit
# Assign GigabitEthernet 1/0/2 to VLAN 4 and configure the port as a host port.
[Sysname] interface gigabitethernet 1/0/2
[Sysname-GigabitEthernet1/0/2] port access vlan 4
[Sysname-GigabitEthernet1/0/2] quit
[Sysname-GigabitEthernet1/0/2] port private-vlan host
# Assign GigabitEthernet 1/0/3 to VLAN 4 and configure the port as a host port.
[Sysname] interface gigabitethernet 1/0/3
[Sysname-GigabitEthernet1/0/3] port access vlan 4
[Sysname-GigabitEthernet1/0/3] port private-vlan host
To Next Page
Loading...
