HPE FlexNetwork 5130 EI Series User Manual

33
interface interface-type interface-number: Specifies an interface by its type and
number. If you do not specify this option, the command displays storm control settings and statistics
for all storm control-enabled interfaces.
Usage guidelines
If you do not specify any keywords, this command displays all storm control settings on all storm
control-enabled interfaces.
Examples
# Display the storm control settings on all storm control-enabled ports.
<Sysname> display storm-constrain
Abbreviation: BC - broadcast; MC - multicast; UC - unicast
KNUC - known unicast; FW - forwarding
Flow Statistic Interval: 5 (in seconds)
Port Type Lower Upper Unit CtrlMode Status Trap Log SwitchNum
-------------------------------------------------------------------------------------
GE1/0/1 MC 100 200 kbps shutdown shutdown off on 10
Table 7 Command output
Field Description
Flow Statistic Interval Traffic polling interval (in seconds) of the storm control module.
Port Abbreviated interface name.
Type
Type of traffic subjected to storm control:
• BC—Broadcast packets.
• MC—Multicast packets.
• UC—Unknown unicast packets.
• KNUC—Known unicast packets.
Lower Lower storm control threshold, in pps, kbps, or percentage.
Upper Upper storm control threshold, in pps, kbps, or percentage.
Unit
Storm control threshold unit:
• pps.
• kbps.
• percentage.
CtrlMode
Action (block or shutdown) taken on the interface when the upper threshold
is reached. N/A indicates that no action is configured.
Status
Packet forwarding status:
• forwarding—The port is forwarding traffic correctly.
• shutdown—The port has been shut down.
• block—The port drops the type of traffic.
Trap
Status of the storm control threshold event trap switch:
• on—The port sends threshold event traps.
• off—The port does not send threshold event traps.
Log
Status of the storm control threshold event log switch:
• on—The port sends threshold event log messages.
• off—The port does not send threshold event log messages.
SwitchNum
Number of forwarding state changes of the interface.
When the
SwitchNum
field reaches 65535, it resets automatically.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English