55
• Do not assign both an aggregate interface and any of its member interfaces to an interface
range. Some commands, after being executed on both an aggregate interface and its member
interfaces, can break up the aggregation.
• Understand that the more interfaces you specify, the longer the command execution time.
• To guarantee bulk interface configuration performance, configure fewer than 1000 interface
range names.
Examples
# Add GigabitEthernet 1/0/1 through GigabitEthernet 1/0/5 to interface range myEthPort, and enter
the interface range view.
<Sysname> system-view
[Sysname] interface range name myEthPort interface gigabitethernet 1/0/1 to
gigabitethernet 1/0/5
[Sysname-if-range-myEthPort]
# Enter the view of interface range myEthPort.
<Sysname> system-view
[Sysname] interface range name myEthPort
[Sysname-if-range-myEthPort]
Related commands
display interface range
To Next Page
Loading...
Need help?
General