Huawei iMaster NetEco V600R021C10 - Page 187

2. In the upper right corner of the RAID Groups area, click Initial Disk
3. Congure disk initialization.
Figure 6-25 Disk initialization (RAID 5 economical conguration by default)
Step 4 Modify the IP address for the IVS1800.
1. Choose Local Conguration > Server conguration. Set the service IP
address (internal IP address of the IVS1800), time zone, and time according to
the site requirements.
Figure 6-26
Conguring the server (Single Mode by default)
NO TE
Set Business IP to XXX.XXX.XXX.XXX, Subnet mask to 255.255.255.0, and Gateway IP
to XXX.XXX.XXX.XXX. The values here are examples. The actual value may vary.
2. Change the PC IP address to an address in the network segment of the new
IVS1800 IP address, enter the IVS1800 IP address in the address box of the
Internet browser, and log in to the OMU portal system.
3. (Optional)
Congure the NTP synchronization. After setting The NTP clock
source server to Yes, set the IP address of the NTP server.
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 176