– The driver protocol of IPC6325 and C3220 cameras is HWSDK.
– The IP address segment indicates the start and end IP addresses of cameras.
5. You can use IP Address to lter the required cameras in the camera search
result and select the required cameras. Alternatively, you can directly select
the required cameras in the camera list. Then verify accounts. The default
password of the SKD protocol is HuaWei123.
Figure 6-34 Verifying accounts
If there are multiple IVS1800s for multiple smart modules, you are advised to evenly
distribute the cameras to each IVS1800.
6. Select the cameras to be added and click Next.
7. Click Finish.
8. Preview live video. On the iClient home page, click Live and drag a camera to
the live video pane. If the live video can be properly played, the camera is
successfully connected.
Step 3
Congure a recording policy.
1. Log in to the iClient and click Device Management on the home page.
2. Right-click an IVS1800 and choose Storage Management.
iMaster NetEco
Device Installation and Commissioning Guide (Data
Center) 6 Adding Devices
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd. 182
To Next Page
Loading...
Need help?
General
