Huawei Quidway S9300

To Next Page

To Previous Page

4.3.8 (Optional) Setting the Time Multiplier of Device Information Held in Neighbor Stations.................4-10

4.3.9 (Optional) Setting the Delay for Re-enabling LLDP on an Interface..................................................4-10

4.3.10 (Optional) Setting the Delay for Sending the Traps of Neighbor Changes........................................4-11

4.3.11 (Optional) Configuring the TLV in the LLDPUD.............................................................................4-11

4.3.12 Checking the Configuration...............................................................................................................4-13

4.4 Maintaining LLDP........................................................................................................................................4-16

4.4.1 Clearing the Statistics of LLDP...........................................................................................................4-16

4.4.2 Monitoring the Operating Status of LLDP...........................................................................................4-16

4.5 Configuration Examples................................................................................................................................4-16

4.5.1 Example for Configuring LLDP..........................................................................................................4-16

4.5.2 Example for Configuring LLDP When an Eth-Trunk Is Used on a Network......................................4-22

4.5.3 Example for Configuring LLDP When an Interface Has Multiple Neighbors....................................4-27

5 Ping and Tracert..........................................................................................................................5-1

5.1 Ping..................................................................................................................................................................5-2

5.2 Tracert.............................................................................................................................................................5-2

5.3 Performing Ping and Tracert Operations........................................................................................................5-3

5.3.1 Establishing the Configuration Task......................................................................................................5-4

5.3.2 Checking Network Connectivity Through the Ping Operation..............................................................5-4

5.3.3 Locating Faults on the Network Through the Tracert Operation...........................................................5-5

5.4 Debugging Ping and Tracert...........................................................................................................................5-6

5.5 Configuration Examples..................................................................................................................................5-6

5.5.1 Example for Performing Ping and Tracert Operations...........................................................................5-6

6 NQA Configuration...................................................................................................................6-1

6.1 Introduction to NQA.......................................................................................................................................6-5

6.2 Comparisons Between NQA and Ping............................................................................................................6-5

6.3 NQA Server and NQA Clients........................................................................................................................6-6

6.4 NQA Supported by the S9300.........................................................................................................................6-6

6.5 Configuring the ICMP Test.............................................................................................................................6-8

6.5.1 Establishing the Configuration Task......................................................................................................6-8

6.5.2 Configuring ICMP Test Parameters.......................................................................................................6-9

6.5.3 Checking the Configuration.................................................................................................................6-10

6.6 Configuring the FTP Download Test............................................................................................................6-11

6.6.1 Establishing the Configuration Task....................................................................................................6-12

6.6.2 Configuring the FTP Download Test Parameters................................................................................6-12

6.6.3 Checking the Configuration.................................................................................................................6-14

6.7 Configuring the FTP Upload Test.................................................................................................................6-15

6.7.1 Establishing the Configuration Task....................................................................................................6-15

6.7.2 Configuring the FTP Upload Test Parameters.....................................................................................6-16

6.7.3 Checking the Configuration.................................................................................................................6-17

6.8 Configuring the HTTP Test...........................................................................................................................6-18

6.8.1 Establishing the Configuration Task....................................................................................................6-19

6.8.2 Configuring HTTP Test Parameters.....................................................................................................6-19

Contents

Quidway S9300 Terabit Routing Switch

Configuration Guide - Network Management

xii Huawei Proprietary and Confidential

Issue 03 (2010-09-20)