Huawei Quidway S9300

MED system information
Device class :Network Connectivity
(MED inventory information of master board)
HardwareRev :LE02SRUA VER.A
FirmwareRev :NC
SoftwareRev :Version 5.70 V100R003C00B042
SerialNum :NA
Manufacturer name :NA
Model name :NA
Asset tracking identifier :NA
System configuration
LLDP Status :enabled (default is disabled)
LLDP Message Tx Interval :60 (default is 30s)
LLDP Message Tx Hold Multiplier :4 (default is 4)
LLDP Refresh Delay :2 (default is 2s)
LLDP Tx Delay :9 (default is 2s)
LLDP Notification Interval :10 (default is 5s)
LLDP Notification Enable :enabled (default is disabled)
Management Address :IP: 10.10.10.1
Remote Table Statistics:
Remote Table Last Change Time :0 days, 0 hours, 0 minutes, 0 seconds
Remote Neighbors Added :0
Remote Neighbors Deleted :0
Remote Neighbors Dropped :0
Remote Neighbors Aged :0
Total Neighbors :1
Port information:
Interface GigabitEthernet1/0/1:
LLDP Enable Status :enabled (default is disabled)
Total Neighbors :1
Port ID subtype :interfaceName
Port ID :GigabitEthernet1/0/1
Port description :HUAWEI, Quidway Series, GigabitEthernet1/0/1 Interface
Port And Protocol vlan ID(PPVID) don't supported
Port VLAN ID(PVID) :0
VLAN name of VLAN 1: vlan1
Protocol identity :STP RSTP/MSTP LACP EthOAM CFM
Auto-negotiation supported :Yes
Auto-negotiation enabled :Yes
OperMau :speed(1000)/duplex(Full)
Power port class :PD
PSE power supported :No
PSE power enabled :No
PSE pairs control ability:No
Power pairs :Unknown
Port power classification:Unknown
Link aggregation supported:No
Link aggregation enabled :No
Aggregation port ID :0
Maximum frame Size :1526
MED port information
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 4 LLDP Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-19