Huawei Quidway S9300

[SwitchA] display lldp local interface gigabitethernet 1/0/2
Interface GigabitEthernet1/0/2:
LLDP Enable Status :enabled (default is disabled)
Total Neighbors :1
Port ID subtype :interfaceName
Port ID :GigabitEthernet1/0/2
Port description :HUAWEI, Quidway Series, GigabitEthernet1/0/2 Interface
Port And Protocol vlan ID(PPVID) don't supported
Port VLAN ID(PVID) :1
VLAN Name of VLAN 1: vlan1
Protocol identity :STP RSTP/MSTP LACP EthOAM CFM
Auto-negotiation supported :Yes
Auto-negotiation enabled :Yes
OperMau :speed(1000)/duplex(Full)
Power port class :PD
PSE power supported :No
PSE power enabled :No
PSE pairs control ability:No
Power pairs :Unknown
Port power classification:Unknown
Link aggregation supported:Yes
Link aggregation enabled :Yes
Aggregation port ID :10
Maximum frame Size :9216
MED port information
Media policy type :Unknown
Unknown Policy :Yes
VLAN tagged :No
Media policy VlanID :0
Media policy L2 priority :0
Media policy Dscp :0
Power Type :Unknown
PoE PSE power source :Unknown
Port PSE Priority :Unknown
Port Available power value:0
l Check the configuration of Switch B.
See the procedure for checking the configuration of Switch A.
# Check whether the member interfaces are added to Eth-Trunk 1.
l Check the configuration of Switch A.
[SwitchA] display eth-trunk 1
Eth-Trunk1's state information is:
WorkingMode: NORMAL Hash arithmetic: According to SIP-XOR-DIP
Least Active-linknumber: 1 Max Bandwidth-affected-linknumber: 8
Operate status: up Number Of Up Port In Trunk: 3
-------------------------------------------------------------------------------
-
PortName Status Weight
GigabitEthernet1/0/1 Up 1
GigabitEthernet1/0/2 Up 1
GigabitEthernet1/0/3 Up 1
l Check the configuration of Switch B.
See the procedure for checking the configuration of Switch A.
----End
4 LLDP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
4-26 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)