The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type ftp
The test type is set to FTP.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other parameters of the FTP Download
test:
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
command.
l To configure the FTP source port number, run the source-port port-numbercommand.
l To configure the FTP destination port number, run the destination-port port-number
command.
l To configure the NQA test packet to be sent without searching the routing table, run the
sendpacket passroute command.
Step 6 Run:
ftp-operation get
The FTP operation type is set to Get.
By default, the FTP operation type is Get.
Step 7 Run:
ftp-username name
The FTP user name is configured.
Step 8 Run:
ftp-password password
The FTP password used during the login is configured.
Step 9 Run:
ftp-filename file-name
The name of the file to be downloaded is configured.
NOTE
During the FTP test, select a file with a relatively small size for the test. If the file is large, the test may fail
because of timeout.
Step 10 Run:
start
The NQA test is started.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-13
To Next Page
Loading...
