Huawei Quidway S9300

l Run:
mtrace-query-type { all-router | last-hop | destination | multicast-tree }
The query type, namely, the mode in which IGMP Tracert Response messages are sent, is
configured for the MTrace test instance.
NOTE
This parameter can be configured only for MTrace test instances.
l Run:
probe-count number
The number of probes for one time is set.
NOTE
This parameter cannot be configured for FTP and DNS test instances.
l Run:
probe-failtimes times
The number of permitted maximum probe failures, that is, the threshold to trigger the trap
message, is set for the NQA test instance.
NOTE
This parameter cannot be configured for Path Jitter, and MTrace test instances.
l Run:
records history number
The maximum number of history records is set for the NQA test instance.
NOTE
This parameter cannot be configured for MTrace test instances.
l Run:
records result number
The maximum number of result records is set for the NQA test instance.
l Run:
remote-pw-id remote-pw-id
The PW ID or VC ID is set for the remote device.
NOTE
This parameter can be configured only for PWE3 Ping and PWE3 Trace test instances.
l Run:
sendpacket passroute
The NQA test is configured to send packets without searching for the routing table.
NOTE
This parameter cannot be configured for DNS, ICMP Jitter, Path Jitter, LSP Ping, LSP Trace, LSP
Jitter, PWE3 Ping, PWE3 Trace, and MTrace test instances.
l Run:
set-df
Packet fragmentation is prohibited.
NOTE
This function can be configured only for the Trace test instances.
l Run:
send-trap { all | { owd-ds | owd-sd | probefailure | rtd | testcomplete |
testfailure } * }
The condition for triggering the trap message is configured.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-117