Huawei Quidway S9300

<SwitchA> system-view
[SwitchA] nqa test-instance admin trace
[SwitchA-nqa-admin-trace] test-type trace
[SwitchA-nqa-admin-trace] destination-address ipv4 10.2.1.2
Step 3 Perform the test.
[SwitchA-nqa-admin-trace] start now
Step 4 Verify the test result.
# Verify the NQA test result on Switch A.
[SwitchA-nqa-admin-trace] display nqa results test-instance admin trace
NQA entry(admin, trace) :testflag is inactive ,testtype is trace
1 . Test 1 result The test is finished
Completion:success Attempts number:1
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Drop operation number:0
Last good path Time:2006-8-5 14:38:58.5
1 . Hop 1
Send operation times: 3 Receive response times: 3
Min/Max/Average Completion Time: 46/47/41
Sum/Square-Sum Completion Time: 125/5349
RTD OverThresholds number: 0
Last Good Probe Time: 2006-8-5 14:38:58.3
Destination ip address:10.1.1.2
Lost packet ratio: 0 %
2 . Hop 2
Send operation times: 3 Receive response times: 3
Min/Max/Average Completion Time: 31/79/62
Sum/Square-Sum Completion Time: 188/13286
RTD OverThresholds number: 0
Last Good Probe Time: 2006-8-5 14:38:58.5
Destination ip address:10.2.1.2
Lost packet ratio: 0 %
----End
Configuration Files
l Configuration file of Switch A
#
sysname SwitchA
#
vlan batch 100
#
interface Vlanif100
ip address 10.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
nqa test-instance admin trace
test-type trace
destination-address ipv4 10.2.1.2
#
ip route-static 10.2.1.0 255.255.255.0 10.1.1.2
#
return
l Configuration file of Switch B
#
sysname SwitchB
#
vlan batch 100 110
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-152 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)