Data Preparation
To complete the configuration, you need the following data:
l Host address of the SNMP agent
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Enable SNMP agent on Switch C.
<SwitchC> system-view
[SwitchC] snmp-agent
Step 3 Create an SNMP query test on Switch A.
<SwitchA> system-view
[SwitchA] nqa test-instance admin snmp
[SwitchA-nqa-admin-snmp] test-type snmp
[SwitchA-nqa-admin-snmp] destination-address ipv4 10.2.1.2
Step 4 Perform the test.
[SwitchA-nqa-admin-snmp] start now
Step 5 Verify the test result.
[SwitchA-nqa-admin-snmp] display nqa results test-instance admin snmp
NQA entry(admin, snmp) :testflag is inactive ,testtype is snmp
1 . Test 1 result The test is finished
Send operation times: 3 Receive response times: 3
Completion:success RTD OverThresholds number: 0
Attempts number:1 Drop operation number:0
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Destination ip address:10.2.1.2
Min/Max/Average Completion Time: 63/172/109
Sum/Square-Sum Completion Time: 329/42389
Last Good Probe Time: 2006-8-5 15:33:49.1
Lost packet ratio: 0 %
----End
Configuration Files
l Configuration file of Switch A
#
sysname SwitchA
#
vlan batch 100
#
interface Vlanif100
ip address 10.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
nqa test-instance admin snmp
test-type snmp
destination-address ipv4 10.2.1.2
#
ip route-static 10.2.1.0 255.255.255.0 10.1.1.2
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-154 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
