1. Configure Switch A as the NQA client. Create an LSP traceroute test on Switch A.
2. Configure Switch C as the NQA server.
Data Preparation
To complete the configuration, you need the following data:
l LSP TE tunnel interface number
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Enable MPLS RSVP-TE on Switch A, Switch B, and Switch C. The configuration details are
not mentioned here.
Step 3 Configure a TE tunnel on Switch A to connect Switch C. The configuration details are not
mentioned here.
For the configuration of MPLS RSVP-TE, refer to the Quidway S9300 Terabit Routing Switch
Configuration Guide - MPLS.
Step 4 Create an NQA test on Switch A.
# Enable the NQA client and configure the LSP traceroute test for the TE tunnel.
<SwitchA> system-view
[SwitchA] nqa test-instance admin lsptracert
[SwitchA-nqa-admin-lsptracert] test-type lsptracert
[SwitchA-nqa-admin-lsptracert] lsp-type te
[SwitchA-nqa-admin-lsptracert] lsp-tetunnel tunnel 1/0/0
Step 5 Perform the test.
[SwitchA-nqa-admin-lspjitter] start now
Step 6 Verify the test result.
[SwitchA-nqa-admin-lspjitter] display nqa results test-instance admin lspjitter
NQA entry(admin, lsptrace) :testFlag is inactive ,testtype is lsptrace
1 . Test 1 result The test is finished
Completion:success Attempts number:1
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Drop operation number:0
Last good path Time:2006-8-24 11:22:21.2
1 . Hop 1
Send operation times: 3 Receive response times: 3
Min/Max/Average Completion Time: 1050/1090/1053
Sum/Square-Sum Completion Time: 3160/3331000
RTD OverThresholds number: 0
Last Good Probe Time: 2006-8-24 11:22:17.2
Destination ip address:10.1.1.2
2 . Hop 2
Send operation times: 3 Receive response times: 3
Min/Max/Average Completion Time: 1050/1490/1323
Sum/Square-Sum Completion Time: 3970/5367500
RTD OverThresholds number: 0
Last Good Probe Time: 2006-8-24 11:22:21.2
Destination ip address:3.3.3.9
----End
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-176 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
