Huawei Quidway S9300

[SwitchA] snmp community read public
[SwitchA] snmp community write private
[SwitchA] snmp sys-info version v2c
[SwitchA] snmp trap enable feature-name nqa trap-name
nqafaillingalarmnotification
[RouterA] snmp trap enable feature-name nqa trap-name nqarisingalarmnotification
# Configure alarms to be sent to the NM station through the SNMP agent.
[SwitchA] snmp target-host trap address udp-domain 11.1.2.8 params securityname
alarm v2c
Step 5 Verify the configuration.
<SwitchA> display nqa-event
NQA event information:
------------------------------------------------------
NQA Event Max: 5 NQA Event Number: 1
------------------------------------------------------
[SwitchA-nqa-admin-icmp] display nqa-alarm
NQA alarm information:
------------------------------------------------------
NQA Alarm Max: 5 NQA Alarm Number: 1
------------------------------------------------------
<SwitchA> display nqa-agent
NQA Tests Max:2000 NQA Tests Number: 1
NQA Flow Max:1000 NQA Flow Remained:1000
nqa test-instance admin icmpjitter
test-type icmpjitter
destination-address ipv4 11.1.1.20
frequency 5
alarm 20 lost-packet-ratio 2 rising-threshold 100 10 falling-threshold 10 10
nqa status : normal
----End
Configuration Files
l Configuration file of Switch A
#
sysname SwitchA
vlan batch 10 20
#
interface Vlanif10
ip address 11.1.1.1 255.255.255.0
#
interface Vlanif20
ip address 11.1.2.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 20
port hybrid untagged vlan 20
#
interface NULL0
#
aaa
authentication-scheme default
#
authorization-scheme default
#
accounting-scheme default
#
domain default
#
#
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-237