Huawei Quidway S9300

By default, NTDP is not enabled in the system view.
l Enabling NTDP on an interface
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
ntdp enable
NTDP is enabled on the interface.
l (Optional) Configuring the range of topology collection
1. Run:
system-view
The system view is displayed.
2. Run:
ntdp hop max-hop-value
The range of topology collection is configured.
By default, the value is 3 hops. The greater the value is, the more memory is occupied.
l (Optional) Setting the delay in forwarding NTDP packets
1. Run:
system-view
The system view is displayed.
2. Run:
ntdp timer hop-delay hop-delay-time
The hop delay in forwarding NTDP packets is set.
3. Run:
ntdp timer port-delay port-delay-time
The interface delay in forwarding NTDP packets is set.
By default, the hop delay is 200 ms and the interface delay is 20 ms.
l (Optional) Setting the interval for collecting topology information
1. Run:
system-view
The system view is displayed.
2. Run:
ntdp timer interval
The interval for collecting topology information is set.
By default, the interval for collecting topology information is set to 0 minutes, that is,
topology information is not collected regularly.
l (Optional) Enabling topology collection
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 8 HGMP Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8-11