The system view is displayed.
2. Run
cluster
The cluster view is displayed.
3. Run:
undo build
A cluster is deleted.
After the command is run on an administrator switch, except the mngvlanid and ip-
pool commands, configurations of the administrator switch in the HGMP cluster view
are deleted; all member switches automatically quit the cluster.
l Disabling a cluster
Do as follows on the administrator switch or a member switch:
1. Run:
system-view
The system view is displayed.
2. Run:
undo cluster enable
The administrator switch or member switch disable the cluster function.
– After the command is run on an administrator switch, except the mngvlanid
command, configurations of the HGMP cluster in the HGMP cluster view are
deleted; all member switches automatically quit the cluster.
– After the command is run on a member switch, the member switch automatically
quits the cluster, without affecting the administrator switch and other member
switches.
l Quitting a cluster
Do as follows on a member switch:
1. Run:
system-view
The system view is displayed.
2. Run
cluster
The cluster view is displayed.
3. Run:
undo administrator-address
The member switch quits a specified cluster.
NOTE
When you run the undo administrator-address command on member switches, the member
switch temporarily exits from the cluster, whereas the administrator switch does not delete the
member switch. To delete a member switch from the HGMP cluster, run the delete-member
command.
----End
8 HGMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
8-16 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
Need help?
General
