Huawei Quidway S9300

Cluster multicast MAC address : 0180-c200-000a(default)
Cluster auto-join : disabled
Handshake timer:10 sec
Handshake hold-time:60 sec
IP pool:10.0.0.1/8
Logging host:4.0.0.1
SNMP host:3.0.0.1
FTP server:2.0.0.1
SFTP server:2.0.0.2
cluster-member ftp-timeout: 300 sec(default)
Cluster SNMP NAT capability : enabled
Cluster FTP NAT capability : disabled
There are 4 member(s) in the cluster, and 0 of them are down.
----End
Configuration Files
l Configuration file of Administrator-1.
#
sysname Administrator-1
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 3
ntdp timer 10
ndp enable
#
interface Vlanif10
ip address 1.0.0.1 255.0.0.0
#
interface gigabitethernet1/0/1
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
interface gigabitethernet1/0/2
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
cluster
mngvlanid 10
ip-pool 10.0.0.1 255.0.0.0
build HUAWEI
cluster-ftp-nat enable
ftp-server 2.0.0.1
sftp server:2.0.0.2
logging-host 4.0.0.1
snmp-host 3.0.0.1
#
ip route-static 0.0.0.0 0.0.0.0 1.0.0.2
#
return
l Configuration file of Member-1.
#
sysname Member-1
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 3
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 8 HGMP Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8-41