Huawei Quidway S9300

Step 10 Edit the list of incremental configuration commands on the administrator switch.
[HUAWEI_0.Administrator-1] cluster
[HUAWEI_0.Administrator-1-cluster] increment
[HUAWEI_0.Administrator-1-cluster-increment] increment-command command-number 10
command-text vlan batch 100 to 200
[HUAWEI_0.Administrator-1-cluster-increment] increment-command command-number 20
command-text ip route-static 2.0.0.0 8 10.0.0.1
After the previous configuration, run the display increment-command command on the
administrator switch to check the list of incremental configuration commands.
[HUAWEI_0.Administrator-1] display increment-command
The content of increment commands:
------------------------------------------------------------------------------
SN Content
------------------------------------------------------------------------------
10 vlan batch 100 to 200
20 ip route-static 2.0.0.0 8 10.0.0.1
Step 11 Deliver the list of incremental configurations command to the specified member switch.
[HUAWEI_0.Administrator-1-cluster-increment] increment-run group-by member-number
2 to 3
Step 12 Verify the configuration.
Run the display cluster-increment-result command on administrator switch to check whether
the list of incremental configuration commands is delivered to the specified member switch, and
you can view that success is displayed.
[HUAWEI_0.Administrator-1] display cluster-increment-result
The result of member switchs executing increment commands:
------------------------------------------------------------------------------
SN Device MacAddress IpAddress Result CommandId
------------------------------------------------------------------------------
2 S9300 0003-0003-0003 10.0.0.3 success -
3 S9300 0004-0004-0004 10.0.0.4 success -
----End
Configuration Files
l Configuration file of Administrator-1.
#
sysname Administrator-1
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 3
ntdp timer 10
ndp enable
#
interface Vlanif10
ip address 1.0.0.1 255.0.0.0
#
interface gigabitethernet1/0/1
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
interface gigabitethernet1/0/2
port link-type trunk
port trunk allow-pass vlan 10
8 HGMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
8-112 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)