EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
630 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cluster multicast MAC address : 0180-c200-000a(default)
Cluster auto-join : disabled
Handshake timer:10 sec
Handshake hold-time:60 sec
IP pool:10.0.0.1/8
Logging host:4.0.0.1
SNMP host:3.0.0.1
FTP server:2.0.0.1
SFTP server:2.0.0.2
cluster-member ftp-timeout: 300 sec(default)
Cluster SNMP NAT capability : enabled
Cluster FTP NAT capability : disabled
There are 4 member(s) in the cluster, and 0 of them are down.
Step 10 Synchronize configuration files.
# Run the configuration synchronization command on the administrator switch, and then member
switches synchronize configuration files to the FTP server (2.0.0.1) in NAT mode.
[HUAWEI_0.Administrator-1] cluster
[HUAWEI_0.Administrator-1-cluster] cluster-plug-play ip 2.0.0.1 username hgmp
password hgmp
[HUAWEI_0.Administrator-1-cluster] increment-config synchronization
Step 11 Verify the configuration.
After the previous configuration, run the display increment-synchronization-result command
on administrator switch to check whether configuration files are synchronized to the FTP server,
and you can view that success is displayed.
[HUAWEi_0.Administrator-1] display increment-synchronization-result
The result of member switchs' synchronization:
------------------------------------------------------------------------------
SN Device MacAddress IpAddress result
------------------------------------------------------------------------------
1 S9300 0002-0002-0002 10.0.0.2 success
2 S9300 0003-0003-0003 10.0.0.3 success
3 S9300 0004-0004-0004 10.0.0.4 success
On the FTP server, you can view that the names of configuration files are the MAC address of
member switches, which indicates that configuration synchronization is successful.
----End
Configuration Files
l Configuration file of Administrator-1.
#
sysname Administrator-1
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 5
ntdp timer 10
ndp enable
#
interface Vlanif10
ip address 1.0.0.1 255.0.0.0
#
interface gigabitethernet1/0/1
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
8 HGMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
8-122 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals