www.izcorp.com • 1.800.776.1356
Shortcut keys:
Session Controller
KC-24 N/A
VARI-SPEED is stored independently for each project,
but must be manually engaged each time the project is
loaded. See OPERATIONS: VARI-SPEED for more details
on using this feature.
RADAR supports up to 99 levels of undo. The factory
default setting is 10. Use this dialogue to customize the
number of undo levels in the current project. This setting
can be changed at any time, however setting this value to
a lower value will delete any undo information that
existed in the higher undo levels. For example: changing
the undo level setting from 10 to 0 and then back to 10
will erase all undo information.
Too many levels of undo can waste disk
space. Disk space cannot be
automatically reclaimed by the system
until deleted audio regions are no longer
accessible via UNDO.
With this option enabled RADAR will automatically stop
playing when it reaches a locate point.
This dialogue sets the signal level threshold for waveform
drawing. Noise and other signals below the noise floor
setting will not be drawn. The threshold value can be
modified in 5-decibel increments between –90.0 and -
60.0.
MAIN/PREFS MENU:
STOP AT LOCATE
MAIN/PROJ MENU:
WAVE NOISE FLOOR
MAIN/PROJ MENU:
UNDO LEVEL
MAIN/PROJ MENU:
VARISPEED
To Next Page
Loading...
