www.izcorp.com • 1.800.776.1356
This preference determines how long the meters will hold
a peak level indication. The duration is specified in
seconds, with a maximum value of 999 seconds. To hold
level peaks indefinitely, enter a value of -1 for this
setting. To disable the feature altogether, enter a
value of 0.
This preference determines how long the clip LED’s will
hold a clip indication. The duration is specified in
seconds, with a maximum value of 999 seconds. To hold
clip indications indefinitely, enter a value of -1 for this
setting. To disable the feature altogether, enter a
value of 0.
This preference item specifies how long RADAR waits
after an operation before it performs its periodic SAVE
STATE, which commits the current state of the system to
the hard disk. The delay is set in seconds with a value
ranging between 1 and 99. The SAVE STATE feature
cannot be disabled.
The default save state delay is 1 second. It
is recommended to leave it on this setting.
Hold the key and press to immediately activate
the screen saver lock mode. Hold the key and
press again to release this mode.
The default screen saver delay is 60 seconds. Delays up
to 999 seconds are possible. Setting the value to 0 will
disable the screen saver feature.
This enables and disables the image effects applied to
the RADAR screen saver.
SCRN-SAVER MENU:
IMAGE EFFECTS
SCRN-SAVER MENU:
SAVER DELAY
MAIN/PREFS MENU:
SCRN-SAVER MENU
MAIN/PREFS MENU:
SAVE STATE DELAY
MAIN/PREFS MENU:
CLIP HOLD TIME
MAIN/PREFS MENU:
PEAK HOLD TIME
To Next Page
Loading...
