www.izcorp.com • 1.800.776.1356
This preference determines the default TC rate for newly
created projects.
All standard SMPTE/EBU formats are supported.
Sets the start time that will be automatically assigned to
new projects.
This allows a default undo level to be set for all new
projects.
This preference sets the wave-drawing noise floor for all
new projects.
For detailed information on networking please refer to
CONFIGURATION: NETWORKING.
The following interface preferences allow the RADAR
to
be configured for FTP and/or file sharing.
Create a network name for the RADAR
Enable or disable DYNAMIC HOST CONFIGURATION
PROTOCOL.
Define the local IP ADDRESS of the RADAR (if DHCP
disabled).
Define the local SUBNET MASK of the RADAR
(if DHCP
disabled).
Enter the IP ADDRESS of the router (if DHCP disabled).
Enter the PRIMARY DNS ADDRESS (if DHCP disabled).
Enter the SECONDARY DNS ADDRESS (if DHCP
disabled).
In some situations, this setting is required to allow email
of debug logs via a specific Internet Service Provider.
INTERFACE PREFS:
SMTP HOST
PROJECT PREFS:
DEF WAVE NS FLR
PROJECT PREFS:
DEF UNDO LEVEL
PROJECT PREFS:
DEF START TIME
PROJECT PREFS:
DEF TC RATE
INTERFACE PREFS:
SECONDARY DNS
INTERFACE PREFS:
PRIMARY DNS
INTERFACE PREFS:
GATEWAY
INTERFACE PREFS:
SUBNET MASK
INTERFACE PREFS:
LOCAL IP ADDRESS
INTERFACE PREFS:
DHCP SERVER
INTERFACE PREFS:
HOST NAME
NETWORK PREFS:
INTERFACE PREFS
MAIN/PREFS MENU:
NETWORK PREFS
To Next Page
Loading...
