Table 4-10: Terminal Screen, Page 5
Field Type Description
No Card Allowed Toggl e If enabled (Y), no
ne of the listed card
types will be permitted at this terminal. If
you select any card type as enabled, this
field automatically switches to disabled
(N).
Binary BAFE (both parity
and
n
o parity)
Toggle Select (Y) to allow this card type.
Invert Data Toggle Select (Y) to invert the card data reported
fro
m the reader.
BCD BAFE (both parity
and n
o parity)
Toggle Select (Y) to allow this card type.
26-Bit Wiegand Inverted To g g le Select (Y) to allow this
card type.
Eyecam, Prox, Indala To g gle Select (Y) to allow this
card type.
26-Bit Sensor Forward Toggle Select (Y) to allow this
card type.
26-Bit Sensor Reverse To ggle Select (Y) to allow this
card type.
Standard Wiegand Togg l e Select (Y) to allow this
card type.
Encrypted Wiegand Toggle Select (Y) to allow this
card type.
Mag Stripe Tog g l e Select (Y) to allow this
card type.
PIN Only Tog g le Select (Y) to allow this
mode. See “PIN
Only” on page 4-36 for details.
Card ID Togg l e Select (Y) to allow the C
ard ID mode.
PIN+Card ID To ggle Select (Y) to allow this mode. See “PI
N +
Card ID” on page 4-36 for details.
Motorola 32-Bit Toggle Select (Y) to allow this
card type.
HID Corporate 1000 Toggle Select (Y) to allow this
card type.
Custom Togg l e Select (Y) to allow this
card type. This
only works if you have a custom version
of the panel that supports your custom
card format.
Custom Format 1 to 8 Togg l e Select (Y) to allow this
custom format.
Meanings of the custom formats 1 to 8
are assigned at the host.
CK721-A User Interface CK721-A Installation and Operation
4-32 24-10349-8 Rev. B
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2012 Johnson Controls, Inc.
To Next Page
Loading...
