Johnson Controls CK721-A - First Level Module Locations in S300-XS; First Level Module Location in S300-XXS

Figure 3-10: First Level Module Location in S300-XXS
All modules come with the hardware required to
mount them. Mount the modules to
the back of the enclosure by using the following procedure:
1. Install the four 5/8 inch standoffs into the nuts located on the back of the
en
closure.
2. Position the module over the standoffs and secure with the mounting screws.
3. Attach RS485 cable from the CK721-A to the module, or module to module.
NOTE
All four mounting screws must be used to ensure proper grounding.
Figure 3-9: First Level Module Locations in S300-XS
1
CK721-A Installation and Operation S300 Expansion Enclosures
24-10349-8 Rev. B 3-9
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2012 Johnson Controls, Inc.
2
1
3