Using a Keypad Reader on a Panel CK721-A Installation and Operation
F-8 24-10349-8 Rev. B
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2012 Johnson Controls, Inc.
To invoke Panel Card Events with PIN and Badge, allowing PIN after
badge:
1. The event’s Trigger Type must be set to Card/Keypad Code or
Card/PIN/Keypad Code.
2. The terminal’s PIN Suppression Timezone must be set to an inactive
timezone.
3. The terminal’s Allow PIN After Badge flag must be set.
4. To activate event:
Without the Star Feature, enter PIN, press A, enter the keypad code, present
the badge
1
, and press the # key.
With the Star Feature, enter PIN, press the star (*) key followed by number 1,
enter the keypad code, present the badge
1
, and press the # key.
5. To deactivate event:
Without the Star Feature, enter PIN, press D, enter the keypad code, present
the badge
1
, and press the # key.
With the Star Feature, enter PIN, press the star (*) key followed by number 4,
enter the keypad code, present the badge
1
, and press the # key.
1
The badge can be presented at any time before the # key is pressed.
QUICK GUIDE TO USING KEYPAD READERS
Use the following quick guide to determine the key sequence at a keypad reader required for
a particular action. This section assumes all terminal’s and panel’s settings have already been
configured for this action.
NOTE
Use the terminal’s Star Feature if you want to invoke Panel Card Events on
a keypad that does not have the keys A and D.
To Next Page
Loading...
