Using a Keypad Reader on a Panel CK721-A Installation and Operation
F-2 24-10349-8 Rev. B
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2012 Johnson Controls, Inc.
4. Make sure the terminal’s PIN + Card ID flag is not set.
5. At the keypad reader, enter the Card ID number and press the # key.
 To invoke access with PIN and Card ID:
1. The terminal’s PIN + Card ID flag must be set.
2. Make sure the terminal’s PIN Only flag is not set.
3. At the keypad reader, enter PIN, then enter the Card ID number and press the
# key.
 To invoke access using PIN and badge:
1. The terminal’s PIN Suppression Timezone must be set to an inactive
timezone.
2. Make sure the terminal’s Allow PIN After Badge flag is not set.
3. At the keypad reader, enter PIN and then present the badge.
 To invoke access with PIN and badge, allowing PIN after badge:
1. The terminal’s PIN Suppression Timezone must be set to an inactive
timezone.
2. The terminal’s Allow PIN After Badge flag must be set.
3. At the keypad reader, present the badge
1
, enter PIN and press the # key.
1
The badge can be presented at any time before the # key is pressed.
INVOKING AIR CREW ACCESS REQUESTS FROM A
K
EYPAD
 To invoke Air Crew access:
1. The host must be online.
2. The respective Air Crew PIN must be enabled for the terminal.
3. To request Air Crew access:
Without the Star Feature, press the B key followed by the Air Crew PIN
number and the # key.
With the Star Feature, press the star (*) key, then press number 2, followed by
the Air Crew PIN number and the # key.
INVOKING TIMED OVERRIDES FROM A KEYPAD
 To invoke Timed Override with Badge:
1. The terminal’s Cardholder Override flag must be set.
2. The badge’s Override flag must be set.
To Next Page
Loading...
Need help?
General
