Figure 4-4: KONE KIC Controller with Multiple Elevator Groups
One KONE KIC Controller with Multiple Elevator Groups
and Multiple
CK721-A Controllers
In this scenario, a single KONE IP controller communicates with multiple CK721-A
controllers. The TCP port
numbers are different for the KONE IP controller to
distinguish the heartbeats.
CK721-A Installation and Operation CK721-A User Interface
24-10349-8 Rev. B 4-45
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2012 Johnson Controls, Inc.
Floor Configuration
A single floor configuration is mapped to each elevator group.
Modes of Operation
The CK721-A supports the following 3 modes of operation:
One KONE KIC controller handling multiple elevator groups
One KONE KIC controller handling multiple elevator groups, connected to
multiple CK721-A controllers
Pair(s) of KONE IP controllers, each pair handling one elevator group
One KONE KIC Controller for All Elevator Groups
In this scenario, all elevator groups use the same TCP port number and are
connected to
a single KONE KIC controller and a single CK721-A controller.
Elevator Group 1
TCP Port 1
Elevator Group 3
TCP Port 1
Elevator Group 3
TCP Port 1
CK721-A: TCP Port 1
KONE KIC
IP Address 1
To Next Page
Loading...
