CK721-A Installation and Operation Using a Keypad Reader on a Panel
24-10349-8 Rev. B F-3
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2012 Johnson Controls, Inc.
3. To be able to invoke Timed Override using badge at any time, set the
terminal’s PIN Suppression Timezone to <0>. Otherwise, Timed Override
will be invoked only during active timezones.
4. To start Timed Override:
Without the Star Feature, press the star (*) key, enter the number of minutes,
and present the badge.
With the Star Feature, press the star (*) key followed by number 0, enter the
number of minutes, and present the badge.
5. To stop Timed Override:
Without the Star Feature, press the star (*) key, enter 0 (for minutes), and
present the badge.
With the Star Feature, press the star (*) key followed by number 0 and
present the badge.
To invoke Timed Override with PIN Only
1. The terminal’s Cardholder Override flag must be set.
2. The badge’s Override flag must be set.
3. The terminal’s PIN Only flag must be set. PIN Only works exclusively with
5-digit algorithmic PINs.
4. Set the panel’s PIN Code Type to Algorithmic.
5. The panel’s 5 Digit Pin Code must be set to 5.
6. To start Timed Override:
Without the Star Feature, enter PIN, press the star (*) key, enter the number
of minutes, and press the # key.
With the Star Feature, enter PIN, press the star (*) key followed by number 0,
enter the number of minutes, and press the # key.
7. To stop Timed Override:
Without the Star Feature, enter PIN, press the star (*) key, enter 0 (for
minutes), and press the # key.
With the Star Feature, enter PIN, press the star (*) key followed by number 0,
and press the # key.
To invoke Timed Override with Card ID:
1. The terminal’s Cardholder Override flag must be set.
2. The badge’s Override flag must be set.
3. To be able to invoke Timed Override using badge at any time, set the
terminal’s PIN Suppression Timezone to <0>. Otherwise, Timed Override
will be invoked only during active timezones.
4. The terminal’s Card ID flag must be set.
5. Make sure the terminal’s PIN Only flag is not set.
To Next Page
Loading...
