JUMO DICON touch - 3 Basic Status

12 Configuration
128
12.12.3 Basic status
This is where settings are adjusted for what should be active in the basic status of the program
controller, that is, if no program is active in automatic mode.
Setup dialog box
Parameters
Parameter Selection/settings Description
Program setpoint value 1 0.00 to 99999 The value entered here is active in
the basic status.
Program setpoint value 2 0.00 to 99999
Control contacts Not selected (empty)
(⎫) Contact 1 to 8 Ticked operating contacts are active
in the basic status.
Parameter set R1/R2 Parameter block 1 to 4 The parameter block set here is
active for both controllers in the
basic status
Active functions Not selected (empty)
(⎫) Limit value monitoring 1 to 12 The ticked limit value monitoring
function is active in the basic status.
(⎫) Controller 1, 2 The ticked controller is active in the
basic status