JUMO DICON touch - Controller Inputs

12 Configuration
82
12.6.2 Controller inputs
This menu is used to configure the input signals of the controller – incl. the signals for switching
off the controller and for parameter block changeover – and the parameters for manual mode.
Setup dialog box
Parameters
Parameter Selection/settings Description
Controller 1, Controller 2
Controller actual value IN8 analog input 1 Analog signal for actual value
Analog selector
Controller setpoint value Setpoint specification for
Controller 1
Analog signal for setpoint value
Analog selector
Output level feedback No selection
Analog selector
Analog signal for output level feedback
Manual output level Analog signal for manual output level
additive variable distur-
bance
Analog signal for additive variable distur-
bance
multiplicative variable dis-
turb.
Analog signal for multiplicative variable
disturbance