JUMO DICON touch - 5 Response by out of Range (O-O-R)

12 Configuration
130
12.12.5 Response by out of range (O-o-R)
Here you can set which parameters should be active in the program controller in the event of
a deviation above or below the measuring range.
Setup dialog box
Parameters
Parameter Selection/settings Description
Program setpoint value 1 0.00 to 99999 The value entered here is active for out
of range parameters.
Program setpoint value 2 0.00 to 99999
Control contacts Not selected (empty)
(⎫) Contact 1 to 8 Ticked operating contacts are active if
out of range applies.
Parameter set R1/R2 Parameter block 1 to 4 The parameter block set here is active
for both controllers if out of range
applies