CONFigure Subsystem Introduction
The CONFigure command provides the most concise way to program the instrument for measurements.
When you execute this command, the instrument uses default values for the requested measurement con-
figuration (same as the MEASure? command). However, the measurement is not automatically started
and you can change some measurement attributes before actually initiating the measurement. This allows
you to incrementally change the instrument's configuration from the default conditions.
Use the INITiate:IMMediate or READ? command to start the measurement.
Command Summary
CONFigure?
CONFigure:FREQuency
CONFigure:FREQuency:RATio
CONFigure:FREQuency:BURSt
CONFigure:FREQuency:PRF
CONFigure:FREQuency:PRI
CONFigure:PERiod
CONFigure:SPERiod
CONFigure:TINTerval
CONFigure:FTIMe
CONFigure:RTIMe
CONFigure:NDUTycycle
CONFigure:PDUTycycle
CONFigure:NWIDth
CONFigure:PWIDth
CONFigure:NWIDth:BURSt
CONFigure:PWIDth:BURSt
CONFigure:PHASe
CONFigure:TOTalize:CONTinuous
CONFigure:TOTalize:TIMed
CONFigure:ARRay:TSTamp
Default Settings for the CONFigure Command
With the CONFigure command, you can select the function, range, and resolution all in one command. All
other measurement parameters are set to their default values as shown below.
Measurement Parameter: CONFigure Setting:
Input configuration Range, low-pass filtering, coupling, impedance, noise rejec-
tion are unchanged.
See the CONFigure commands for the different meas-
urement functions for information about level and slope.
CONFigure Subsystem Introduction
112 Keysight 53220A/53230A Programmer's Reference
To Next Page
Loading...
