MEASure:NWIDth:BURSt?
Syntax
MEASure:NWIDth:BURSt? [<channel>]
Description
This query sets all measurement parameters and trigger parameters to default values for negative ("off
time") width measurements of a pulsed input signal, then immediately triggers a measurement. The res-
ults are sent directly to the instrument output buffer.
Parameters
Name Type Range of Values Default Value
<channel> Expression (@3) (@3)
Remarks
l Available only on the Keysight 53230A. Requires option 150.
Return Format
The query returns a single measurement. The format of the measurement is controlled by the FORMat
Subsystem commands.
Examples
The following example configures the instrument for pulse width measurements on channel 3 using
default parameters, makes one measurement, and then transfers the measurement to the instrument out-
put buffer.
MEAS:NWID:BURS?
Typical Response: +5.10520000000000E-006
See Also
CONFigure?
FETCh?
READ?
MEASure:NWIDth:BURSt?
260 Keysight 53220A/53230A Programmer's Reference
To Next Page
Loading...
