Keysight 53230A - Memory:state:delete

MEMory:STATe:DELete
Syntax
MEMory:STATe:DELete {0 | 1 | 2 | 3 | 4}
Description
This command deletes the contents of the specified storage location.
Remarks
l Although you may delete the state location 0, it will be recreated when the instrument is powered off.
l You cannot delete a storage location if it is selected and enabled for automatic power-on recall using
the MEMory:STATe:RECall:SELect and MEMory:STATe:RECall:AUTO commands. You must either dis-
able power-on state recall using MEMory:STATe:RECall:AUTO OFF or selected a different state using
MEMory:STATe:RECall:SELect before deleting a selected and enabled state.
l Note that you cannot recall the instrument state from a storage location that was deleted. An error is
generated if you attempt to recall a deleted state.
l The MEMory:STATe:DELete and MEMory:STATe:DELete:ALL commands delete, but do not sanitize,
stored states.
l SYSTem:SECurity:IMMediate command deletes and sanitizes all stored states.
Examples
The following example deletes the contents of storage location 1.
MEM:STAT:DEL 1
See Also
*SAV
*RCL
MEMory:STATe:DELete:ALL
Keysight 53220A/53230A Programmer's Reference 281
MEMory:STATe:DELete