SENSe:TSTamp:RATE
Syntax
[SENSe:]TSTamp:RATE {<rate> | MINimum | MAXimum | DEFault}
[SENSe:]TSTamp:RATE? [{MINimum | MAXimum | DEFault}]
Description
This command selects the nominal rate at which timestamp data is produced. The actual rate will depend
on the input frequency.
Parameters
Name Type Range of Values Default Value
<rate> Numeric 10.0E3, 100.0E3,
800.0E3 or 1.0E6
MIN = 10.0E3
MAX = 1.0E6
1.0E6
Remarks
l Available only on the Keysight 53230A.
l The instrument sets the timestamp rate to 1.0E6 after a Factory Reset (*RST command) or after an
Instrument Preset (SYSTem:PRESet command).
Return Format
The query returns the timestamp rate in the form +1.00000000E+006.
Examples
The following example makes 5,000 timestamp measurements on channel 1 at a rate of up to 1,000,000
per second. Note that the prescaler value is returned followed by the timestamps.
CONF:TST (5000)
TST:RATE 1E6
READ?
Typical Response: +13,+1.29383828200000E-006,+1.29352315400000E-006,...
(5000 meas-
urements)
Keysight 53220A/53230A Programmer's Reference 377
SENSe:TSTamp:RATE
To Next Page
Loading...
