SYSTem:BEEPer:STATe
Syntax
SYSTem:BEEPer:STATe {OFF | ON}
SYSTem:BEEPer:STATe?
Description
This command disables or enables the beeper tone. The factory default is ON.
Remarks
l
Turning off the beeper does not disable the key click generated when you press a front-panel key.
l A beep tone is always emitted (even with the beep state turned OFF) when the SYSTem:BEEPer com-
mand is sent.
l A beep tone is emitted only if the beep state is ON when an error is generated or when an lower or upper
limit is exceeded in a limit test.
l The beeper setting is stored in non-volatile memory, and does not change when power has been off,
after a Factory Reset (*RST command), or after an Instrument Preset (SYSTem:PRESet command).
l The beeper is enabled when the instrument is shipped from the factory or after a SYSTem:SECur-
ity:IMMediate command.
Return Format
The query returns the beeper enable state: 0 (OFF) or 1 (ON).
Examples
The following example disables the beeper state.
SYST:BEEP:STAT OFF
See Also
SYSTem:BEEPer[:IMMediate]
SYSTem:BEEPer:STATe
440 Keysight 53220A/53230A Programmer's Reference
To Next Page
Loading...
